FTB-103渦輪機流量計 美國omega

渦輪機流量計，采用經濟型滾珠軸承設計
FTB-100 Series
渦輪機流量計，采用經濟型滾珠軸承設計

NIST證書
1 / 2%的讀數精度±
非金屬軸承的壽命長
更換軸承領域可不丟失校準
拆卸快速方便維修
導流錐穩定低質量轉子軸承壽命增加
4到20毫安，0-5 V，和縮放的頻率輸出

The FTB-100 Series of turbine meters have a sealed ball bearing design for high accuracy performance (±?% of reading, not full scale) at an economical cost. The non-metallic bearing retainers minimize friction, thereby allowing these meters to be used with clean fluids that have poor lubricating properties ( i.e.water). Ball bearings also give the widest linear flow range, particularly in larger turbines. Bearing replacement and clean-up are fast and easy, since all internal parts are easily accessible by removing a single nut.
These turbine flowmeters have a low mass rotor design which allows rapid dynamic response, so they can be used in pulsating flow applications. Deflector cones eliminate downstream thrust on the rotor and allow hydrodynamic positioning of the rotor between the cones. This provides wider rangeability and longer bearing life than conventional turbine flowmeters. Integral flow-straightening tubes minimize the effects of upstream turbulence.
FTB-100 Turbine Meters are available with integral signal conditioners (as shown in photo) which provide scaled and unscaled frequencies, 4-20 mA, or 0-5 Volt outputs. Units without integral signal conditioners are supplied with mating connector for two-wire hook-up.
SPECIFICATIONS
Accuracy: ±?% of reading
Repeatability: ±0.1% of reading
Maximum Temperature Range: -268 to 232°C (-450 to 450°F)
Maximum Intermittent Overrange: 150% of maximum range
Minimum Output Amplitude: 30 mV Peak-to-Peak Unscaled Pulse
Materials of Construction:
Body: 304 stainless steel; 1/2 NPT bodies contain Silver Solder. 3/4 NPT and larger are welded.
Rotor: 17-4 pH steel
Bearings: Ceramic
Minimum straight pipe requirements: 10 pipe diameters upstream, 5 downstream

產品型號/產品描述
FTB-101 0.35-3.5 GPM Range, Water; 1/2 MNPT
FTB-102 0.75-7.5 GPM Range, Water; 1/2 MNPT
FTB-103 1.25-9.5 GPM Range, Water; 1/2 MNPT
FTB-104 1.75-16 GPM Range, Water; 3/4 MNPT
FTB-105 2.5-29 GPM Range, Water; 3/4 MNPT
FTB-106 4-60 GPM Range, Water; 1 MNPT
FTB-107 6-93 GPM Range, Water; 1? MNPT
FTB-108 8-130 GPM Range, Water; 1? MNPT
FTB-109 15-225 GPM Range, Water; 2 MNPT
FTB-110 25-400 GPM Range, Water; 2? MNPT
FTB-111 40-650 GPM Range, Water; 3 MNPT
注釋: Comes with NIST certificate for water and complete operator’s manual.
Standard NIST calibration: Viscosity = 1CK: no charge; 0.8 CK to 0.99 CK: add $369; 2 CK to 100 CK: for FTB-101 through FTB-107, add $369; for FTB-108 and FTB-109, add $356, and for FTB-110 and FTB-111, add $465.
If an integral signal conditioner is required please order as a system. Omega will scale the signal conditioner to the turbine meter.
 

FTB-103渦輪機流量計 美國omega

美國omega FST1001R經濟型氣流開關