1．Download：
【Software】 【64Driver】 【Manual】 【Firmware】 【SDK】
2．Accessories：
|
|
|
|
|
|
|
|
|
|
|
| |
3.Other Pictures
|
Connected to the computer can be used as a virtual oscilloscope |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
4. Characteristic（Handheld Oscilloscope/Multimeter）
• 全隔離手持示波表，示波器通道間隔離，示波器和萬用表通道隔離，示波器、萬用表與USB等通訊接口之間隔離，隔離等級:1000V CATII,600V CATIII.
• High Bandwidth 60MHz-200MHz Oscilloscope,1GS/s sample rate, and 6000 Counts DMM with analog bargraph , and data recorder.
•
• High Refresh Rate （2500 frames）
• Large 5.6 inch TFT Color LCD Display，High Resolution（640480）, Dual-Window Design --More clear, More Detailed
• One-touch automatic setup optimizes the position, range, timebase, and triggering to assure a stable display of virtually any waveform
• Easy-to-use pop-up menu with built-in multi-language help system
• 23 Automatic Measurements
• Waveform Math: Add, Subtract, Multiply, and Divide
• Store and recall over
• Automatic cursor tracking measurements
• XY Mode
• Built-in FFT function converts a time-domain signal into its frequency components to measure harmonic content and distortion in systems
• Waveform Recorder to capture/replay input waveforms from CH1 and CH2 with a maximum record length of 1000 frames
• Pass-Fail function compares a stored waveform to an unknown input
• Average Mode for smoothing waveforms
• Square Wave Output （2V, 1kHz） for probe adjustment
• USB Host/Device 2.0 full-speed interface ,support removeable disk, LAN Optional ,Easy to control by PC or long-distance.
• Dimensions （mm）:240（L）x165（W）x50（H）, be carried easily.
• Labview\VB\VC Second Design instance.
5. Hardware Specification
| Model | DSO1202S | DSO1122S | DSO1062S |
| Oscilloscope mode | |||
| Bandwidth | 200MHz | 120MHz | 60MHz |
| Real-time Sample Rate | 1GSa/s | ||
| Equivalent Sample Rate | 25GSa/s | ||
| SEC/DIV Range | 2nS/div-2000S/div （in a 2, 4, 8 sequence） | ||
| Delay Time Accuracy | 500ps | ||
| Vertical | |||
| A/D Converter | 8-bit resolution | ||
| VOLTS/DIV Range | 2mV/div～5V/div at input BNC | ||
| | ±50V（5V/div）,±40V（2V/div～500mV/div）, ±2V（200mV/div～50mV/div）±400mV（20mV/div～2mV/div） | ||
| Record Length | Single-channel: Maximum | ||
| Trigger | |||
| Trigger Sensitivity | DC: CH1/CH2（Typical） 1div from DC to 10MHz;1.5div from 10MHz to Full | ||
| | CH1,CH2: ±8 divisions from center of screen | ||
| Trigger Level Accuracy, | CH1,CH2: ±（0.3div×V/div） （within ±4 divisions from center of screen） | ||
| | 100ns-10s | ||
| Trigger Type | |||
| Edge | Trigger on the rising or falling edge | ||
| Pulse Width | Trigger （when >,<,=,≠） on positive or negative pulses | ||
| Video | Trigger on an NTSC, PAL, or SECAM standard video signal | ||
| Slope | Trigger （when >,<,=,≠） on a positive or negative slope | ||
| Overtime | from the rising or falling edge | ||
| Alternate | Internal trigger on edge, pulse width, video or slope | ||
| Measurement | |||
| Cursors | Manual: The difference between voltage cursors △V; the difference between time cursors △T; 1/△T calculated by Hz. | ||
| Automatic | Pk-Pk, Max, Min, Mean, Cyc RMS, Frequency, Period, Rise Time, Fall Time, Positive Width, Negative Width | ||
| Meter Mode | |||
| Max.Resolution | 6,000 Counts | ||
| DMM Testing Modes | Voltage, Current, Resistance, Capacitance,Diode & Continuity | ||
| Max. Input Voltage | AC: 600V, DC: 800V | ||
| Max. Input Current | AC: | ||
| Input Impedance | 10 MΩ | ||
| Isolation | |||
| The float voltage between BNC and Ground | 600V CATIII, 1000V CAT II | ||
| The float voltage between each Channel | 600V CATIII, 1000V CAT II | ||
| The float voltage between Multimeter and Ground | 1000V | ||
| between input Ports directly | 400V CAT II | ||
| Input by 10:1 probe | 600V CATIII, 1000V CAT II | ||
| The Max input voltage of Multimeter | DC 800V,AC 600V | ||
| Display | |||
| Type | Right angle 5.6 16-digit color LCD | ||
| Resolution | 640480 dots | ||
| Contrast | 16 gears, with the progress bar to show adjustment | ||
| Interface | USB host and USB slave, Lan Optional | ||
| Power Supply | |||
| Voltage | DC Input:12--17VDC, 2000mA | ||
| Mechanical | |||
| Size | 245 x 163 x 52 （mm） | ||
| Weight | | ||
6．Software：
Operating system: Windows NT, Windows 2000, Windows XP ,
7．SecondDesign：
Supply DEMO code （VC、VB、LABVIEW）
所有評論僅代表網友意見，與本站立場無關。