1、上熔膠+大鍋膠
Pre-melt system+Big glue pot
自由切換EVA與PUR，實現不同膠水封邊的生產需求。
Reserve for PUR options, EVA& PUR glue can flexibly switch according to customerneeds.
實現多種形狀的修邊工藝。
Realizes various chamfer trimming.
3、雙拋光機構
Double fixation Buffing
清除板件上下面的余膠和碎屑。
Remove excess glue and debris from the top and bottom of the board.
智能操作快捷方便。
2、預銑機構
Pre-milling Unit
標配40mm預銑機構，可修正板材封邊面，使封邊條與板材能貼合更緊密，整體性和美觀度更佳。
Standard with 40T pre-milling cutter, to trim off the defects of panel surface, and thus to achieve a close sticking and a better edge results.
3、預熱機構
Pre-heating Unit
預熱板件，提升板材與邊帶的粘合效果。
Workpiece pre-heats to improve a better edging result.
4、齊頭機構
End-cutting unit
通過精密的直線導軌運動，快速切斷板材前后多余邊帶。確保切斷面平整光滑。并配備自動潤滑系統，根據運行次數自動注油，確保齊頭機構運行順暢，提升使用壽命。
5、修邊機構
Trimming unit
將突出于木板上下表面多余邊帶切除，使封邊帶上下邊緣與木板的上下表面平齊。
Remove the excess and protruding edge bａnd from upper and lower sides of the board, so that the upper and lower edges of edge bａnd will be aligned with board surfaces.
6、刮邊機構
Scraping Unit
用于消除修邊非直線運動的切削過程所引起的波紋痕跡，使板材上下部分更加光滑整潔，配備定向吹絲功能，防止絲帶卷入電機主軸引發故障。
It is used to eliminate the ripple marks caused by the cutting process of the non-linear motion when trimming, so that the upper and lower parts of the board are more smooth and tidy.
Equipped with directional blowing function to prevent the ribbon from being caught in the main spindle of the motor and causing failure.
7、清潔脫模機構
Clean&Spray Unit
在待封邊的板件上下面噴脫模劑，有效防止封邊過程中溢出的熱熔膠粘染板面。清除殘余膠，保持板面清潔。
Spray the clean dust/chips off the panel surface，The spray agent can effectively isolate hot-melt glue stock on the panel surface.Remove residual glue and keep the board clean.
