雙上熔膠系統
[Double Pre-melts System]
快換式上熔膠，拆換便利、快捷，膠鍋液位高精儀器監測，自動預熔、抽膠粒。
Quick-change glue pot and glue level sensor-equipped, EVA glue pre-melts and automatically applies.
膠箱儲量大，滿足長時間供膠，減少人工加膠頻率。
With the large capacity of glue box, it can satisfy the EVA long-time supply and reduce times in manual application.
快速跟蹤機構
[High Speed Corner-rounding]
采用高頻馬達修邊電機，快速、穩定，對前后兩端封邊帶，進行精準的仿形圓角修邊。
High-frequency trimming motor applied, ensures a fast and stable chamfer trimming on corner edges.
數據采集對接端口
[Data Collection]
記錄設備運行信息。
Real-time recording of machine operation information.
履帶壓料
[Belt-type Pressure Beam]
壓緊接觸面積大，確保木板高速輸送的穩定性，提升封邊品質。
A large contact area on the panel ensures a stable conveys with high speed, improving edging quality.
預銑機構
[Pre-milling Unit]
標配40mm銑刀(選配65mm)。
Standard with 40mm milling cutter (optional 65mm).
雙銑刀修飾開料后產生的波紋痕跡、毛刺或不垂直等瑕疵，使封邊條和板材貼合更緊密，提高封邊效果。
Effectively mill off the defects left after cutting, ensuring a close sticking and improving edging results.
預熱
[Pre-heating Unit]
預熱板件，提升板材與邊帶的粘合效果。
Panel preheats to improve a better adhesiveness between panel and tapes.
兩組五輪壓貼
[Five-wheel Pressing]
強力壓合邊帶，提高封邊粘合效果。
Strongly pressure to improve adhesiveness.
雙導軌齊頭機構
[Double-Rail End Cutting]
快速切斷板件前后多余邊帶，前后單獨導軌配置，高效，快捷。
Fast cut off the recessives tapes in front&rear.
配備自動潤滑系統，根據運行次數自動注油，確保齊頭機構運行順暢，提升使用壽命。
The lubricattem is equipped, and automatically works according to running times, ensuring smooth action and prolonging the service life.
往復式拋光
[Buffing Units]
清除板件上下面的余膠和碎屑。
Clean excess glue and chips off the panel top and bottom.
自動潤滑系統
[Auto Lubricattem]
根據機器運轉的時間，定時自動給導軌注油。
Automatically applies grease to the guide rail according to running time.
