Scot Capacity Meter for the determination of metal powder density

Product Introduction

Determination of bulk density of metallic powders — Part 2: Scot volumetric method.The test device is suitable for the funnel with a diameter of 5mm which cannot flow freely through the funnel method and the powder with characteristics easily changed by the vibrating funnel method.

1 Principle :

The powder is then placed on a sieve in the upper combined funnel and fed into the cloth case naturally or externally. It is then fed into a cylindrical cup of known volume in an unnatural manner, alternating with four glass plates and square funnels with an incline of 25° in the case.Then weigh the mass of the powder in the cylindrical cup.

2 instrument composition:

2.1 Upper combination funnel: Assembled by two stainless steel conical funnels, with a section of cylinder separated, and put into a stainless steel sieve with an aperture of 1.18mm.

2.2. Material box: The cross-section is square, and there are four 1mm thick stainless steel plates mounted on the aluminum frame at an oblique Angle. The front and rear walls of the frame are plexiform plates;The stainless steel plate is removable for easy cleaning.

2.3. Square funnel: A 1mm thick stainless steel cone with an inclined Angle of 60° and a lower diameter of 12.5mm×12.5mm.

2.4 Cylindrical cup: the volume is 25 cm3, 0.05 cm3, and the internal diameter is 30. M soil 1 mm.Stainless steel

2.5 Bracket: used for supporting upper combined funnel, cloth box, square funnel, cylindrical cup and other components.

Scot Capacity Meter for the determination of metal powder density

3 Test Steps:

3.1 Carefully place the powder on the sieve of the upper combined funnel with a spoon, pass through the cloth box and the square funnel, and flow into the cylindrical cup until it is full and the powder spills over.

3.2 If the powder cannot pass through the sieve freely, a soft bristle brush can be used to brush the powder through the sieve.If not, the metal powder is not suitable for the determination of loose packing density by the Scott-volumetric method.

3.3 Scrape the cylindrical cup flat with stainless steel plate after powder overflow.Do not compress or take the powder out of the cup, let alone make the cup shake or vibrate.

3.4 After scraping, gently tap the cup to sink the powder, so as to avoid powder loss during the moving process, and no powder should be stained on the surface of the cup.

3.5 Weigh the metal powder in the cylindrical cup, accurate to 0.05g.

Scot Capacity Meter for the determination of metal powder density

4 calculation of test results:

The ratio of the mass to the volume of the metal powder is the loose packing density, and the calculation formula is as follows:

In the formula, as: powder loose density, g/cm3, as measured by the Scott volumeter method,

M: Weight of powder: G

V: Powder volume, cm3.