TD-6021油封旋轉性能試驗機

Oil seal circumgyrating performance tester

概述

油封旋轉性能試驗機適用各種回轉式油封進行密封性能的試驗和研究工作，油封安裝在試驗機上，主軸以一定的速度回轉，經過一定時間的運行，觀察油封是否滲漏，每次可試驗2件油封，測試軸可正、反轉。本機結構合理，設計新穎，起動性能性好，起動力矩大，調速范圍廣，轉速變化率小，噪聲低，操作方便。符合GB/T 14273《旋轉軸唇密封圈性能試驗方法》等標準要求。

Features and use: It suits for testing oil seal performance of all kinds of turn round type oil seal.Oil seal is putting on the tester and principal axis turns round with a certain speed.Whether the oil seal has leakage after running is important.It can test 2 pieces every time. Test axis can turn positively and negatively.The tester structure is in reason,starting performance is good,ａnd timing range is extensive,noise is low.It suits for GB/T 14273.

技術參數：
1、主軸轉速：6000r/min(也可按用戶要求確定)
2、主軸跳動誤差：小于±0.03mm
3、軸心偏置調整量：0mm--5mm
4、可測試油封軸孔范圍：Ф7mm--Ф200mm
5、溫控范圍：常溫--120℃
6、控制方式：變頻調速、氣動加壓，直 線導軌，PLC控制
7、電機功率：2.2kw×2
8、電 源：AC380V三相四線制（必須有零線）

 50Hz
9、外型尺寸：1300mm×1000mm×1500mm
10、重 量：420kg

Main Parameters:
1、Principal axis rev: Max 6000r/min(according to customer's needs)
2、Principal moving up and down error: ＜±0.03mm
3、Axle centre deviating adjusting amount: 0mm--5mm
4、Oil seal axle hole range that can be tested:Ф7mm--Ф200mm
5、Range of temperature controlled: normal temperature--120℃
6、Controlled method: shift gears with frequency
conversion,line guide and PLC.
7、Power of motor: 2.2kw×2
8、Power supply: AC380V 3-phase 4-wire system 50HZ
9、Overall dimension: 1300mm×1000mm×1500mm
10、Weight: 420kg